Food & Pharmaceutical

General Manufacturing

Conveyor lengths: up to 120'
Belt widths: 8" to 36"
Belt speed: up to 195 ft/min maximum
Load up to 20 lbs /square foot of belt
Degree of curves: 15º - 180º
Continuous TIG welded 304 stainless steel frame
Maximum of 2 Curves per conveyor with up to 240º total degrees of turns (Up to 4 curves is possible dependent upon length and degree of curves)
Bearing material is 400 stainless steel
Bearing lubricant is H1 type FDA lubricant
Wear strip material is UHMW
FDA approved belting & plastic components

Continuous welded rame is constructed of 304 stainless steel and designed with no horizontal surfaces for optimum cleaning. Conveyors over 20' consist of multiple sections which are bolted together
Solid UHMW wear strips are easily lifted out of the frame without tools to minimize cleaning time
Conveyor is designed to withstand high pressure (100-1500 PSI) spray and chlorinated solutions
Optional frame cut-outs are available to allow spraying the inside of the conveyor without lifting the belt
The return belt supports are segmented plastic slide blocks
Drive sprockets are mounted to a 1.5" square stainless steel shaft without fasteners to provide optimum drive strength and cleanability
Optional belt lifters raise the belt from the wear strips by simply pulling an external lever for fast access and effective cleaning
An optional nose bar drive configuration allows the use of the nose bar transfer on each end of the conveyor for small product transfers