FD, FV, S Series Fluff Blowers & Cyclone Separators
Scrap handling and reclaim for a variety of processes - FD and FV conveying systems are used to convey ground film scrap to the fluff feed unit or storage tank. FD Series fluff blowers feature direct drive motors, and FV Series blowers feature belt drive motors. The S Series cyclones can be used with fluff feed hoppers or fluff storage tanks.
FD, FV, S Series Fluff Blowers & Cyclone Separators Literature
FT Series Agitated Fluff Storage Tank
Scrap handling and reclaim for a variety of processes - Sterling agitated fluff storage tanks are designed with heavy-duty agitators to handle the hardest to feed materials. Sizes range from 50 to 200 cu. ft. capacity.
FT Series Agitated Fluff Storage Tank Literature
SGR1 Series Single-Chamber Film Grinder
Scrap handling and reclaim for a variety of processes - SGR1 Series film grinders are designed to handle a wide range of materials and can be equipped with our exclusive feed roll assemblies for automatic feeding of scrap roll stock. SGR1 Series film grinders are used to grind film scrap into small particles of fluff that can be combined with palletized material and fed back into an extruder.
SGR1 Series Single-Chamber Film Grinder Literature
SGR2 Series Dual-Chamber Film Grinder
Scrap handling and reclaim for a variety of processes - HBDŽ film grinders use dual cutting chambers to reduce the fluff to a smaller particle size, providing a higher bulk density which results in higher re-feed rates. Scrap film first passes through a primary upper cutting chamber, then through a secondary lower chamber with a smaller screen. HBDŽ grinders are excellent for tacky, heat-sensitive materials like LLDPE and PVC. The HBDŽ Series grinder design permits a very high light speed edge trim because the top chamber stays evacuated to enable efficient ingestion of materials. Excellent for high-speed cast film lines.
SGR2 Series Dual-Chamber Film Grinder Literature
STE Series Fluff Feed System
Scrap handling and reclaim for a variety of processes - STE Series economy trim re-feed systems are designed to run at a set percentage of extruder speed (rpm). Signal isolation circuitry receives extruder tachometer signals to determine system speed. Each auger can be adjusted independently, using the controls on the front panel. STE fluff feed hoppers are designed to feed edge trim back into an extruder at a maximum rate 20% of the extruder output. NOTE: Cannot be used with grooved feed throats.
STE Series Fluff Feed System Literature
STFH Series Fluff Feed Hopper System
Scrap handling and reclaim for a variety of processes - Sterling fluff feed hoppers are designed to feed a percentage of the fluff directly back into the extruder throat. The unique dual-stage design ensures that the fluff is mixed with the virgin material above the extruder throat. Each auger is independently adjustable and can be set to follow the extruder screw speed by monitoring a tachometer signal from the extruder. STFH fluff feed hoppers are designed to feed edge trim and roll scrap back into an extruder at a maximum rate of 30% of the extruder output. The SFTH-HP is designed for those applications where scrap re-feed greater than 30% is common. NOTE: Cannot be used with grooved feed throats.
STFH Series Fluff Feed Hopper System Literature
VI Series Edge Trim Conveying System
Scrap handling and reclaim for a variety of processes - VI Series edge trim conveying systems are used to convey edge trim to the film grinder. The systems include a high-pressure radial blade blower, an adjustable blower inlet damper with finger guard, a flanged outlet, and a high-efficiency venturi unit with adjustable venturi tube.
VI Series Edge Trim Conveying System Literature